Description

The AT-1000 is a sub-microbic compressed air filter designed to reduce even the smallest air contaminants from the compressed air entering the Plasma Cutter. It also removes condensed moisture and oil aerosol. The ”AT 1000’ can filter up to 1250 Iiters a minute without reduction in pressure. It’s recommended to replace the filter cartridge every 5 to 7 days.

Plasma cutting demands a clean, oil free and dry condensed air source. This filter will ensure the compressed air running through your machine will not compromise its performance. Using a plasma cutter without the “AT 1000” fitted will result in condensed moisture remaining in the torch and torch head. This moisture can cause a short-circuit, with subsequent costs for the
replacement of the torch head.

Suits all Plasma Cutters
6 filter value pack 
Perfect for painters running compressed air
Pneumatic tools
Spray painting to remove moisture from the air compressor.
Comes complete with blue filter and housing as pictured. 
Comes with mounting bracket. 
Made in Italy with Exceptional Quality
Spare O rings can be found in our store – Search for 50505-OR
Torque housing to  15 to 18 nm to ensure a good seal. 

Features

Suits paper roll filters
Single thumb lock
1/4″ NPT thread
125psi (8.5 bar) maximum pressure (Do not over tighten the O ring) 
0.01 micron filtration
132mm diameter x 200mm high canister
1250l/min. maximum flow

Includes

6 x filter cartridge
6 x flat mounting bracket
6 x 90º mounting bracket
18 x self tapping screws
36 x M8 x 16mm bolts
6 x M8 flat washers
6 x M8 nuts